INSTALLATION
19
18V DC Power Supply with Daisy-Chain Connections
The daisy-chain feature allows up to three PowerView
®
Gen 3 Automation blinds to be
powered by a single 18V DC Power Supply. However, each blind has its own transceiver and
can operate independently. The daisy-chain feature is only available with the 18V DC Power
Supply option.
■
Route the power cables from each blind through the connector, using an extension cable,
if necessary.
■
Plug an extension cable into the Y-connector and plug the cable into the 18V DC Power
Supply. A two-blind configuration is shown below.
■
An additional Y-connector and two additional extension cables are used for three blinds.
Proceed to “Testing the Blind” on page 21.
Attach the Valance with Magnetic Valance Clips
■
Align the valance to the headrail.
■
Hold the valance securely from the front side with both
hands.
■
Position the clips to the top-front lip of the headrail until
it is level and in position.
■
Press the valance gently forward, just enough so the clips
adhere to the headrail.
■
The magnetic valance clips allow for limited valance height adjustments by carefully
sliding the clip up or down while the magnets are adhered to the headrail. The clip’s tabs
rest on the top-front lip of the headrail, keeping the valance level and preventing the
valance from adjusting lower beyond that point.
■
To remove the valance, gently pull the valance up and toward you.
CAUTION:
The entire surface area of the magnet inside each clip needs to maintain
clean contact with the front surface area of the headrail at all times.
Power Cable
from Blind
Extension
Cable
Y-Connector
Summary of Contents for EverWood
Page 34: ...CHILD SAFETY 32 ...
