Hunter TCX575, Operation Instructions Manual

Page: 34 / 48

26

2. Basic Procedures Operation Instructions for TCX575 Tire Changer
With the tire in position, press the wheel rotation pedal to rotate the wheel
clockwise. The tire will be stalled and the rim will rotate to allow the Match Mounting
procedure.
2.6 Tire Inflation
Verify that the wheel has been properly clamped and centered.
WARNING: Never attempt to inflate a tire that is clamped from the
outside. If possible, re-clamp the wheel from the inside
before inflating.
Verify that both upper and lower tire beads and rim bead seat have been properly
lubricated with an approved mounting paste.
Remove valve stem core if not already done.
Connect inflation hose to valve stem.
Pull up on the tire lightly to reduce the gap between upper bead and the rim.
WARNING: Do not stand over tire during inflation.
Step down completely on the air inflation pedal (pedal on the left side of the base) to
release a high-pressure air blast through jets on the clamps to assist in seating the
beads of the tire.
NOTE: To increase the effectiveness of the inflation jets, always
liberally lubricate beads and raise the lower bead while
activating inflation jets.
Step down partially on the pedal to inflate tire and seal beads with inflation hose.
Frequently stop to check bead seating pressure on gauge.
WARNING: Do not exceed tire manufacturer’s maximum pressure
as stated on the sidewall of the tire when seating beads.
Reinstall valve stem core into the valve stem after beads have been seated, and then
inflate tire to vehicle manufacturer recommended pressure.
If tire is over-inflated, air may be removed from the tire by pressing the brass manual
air release button located below the air pressure gauge.