Hunter AutoComp Elite, Operation Instruction Manual, Page: 5 / 33

GETTING STARTED 1
1. Getting Started
1.1 Introduction
This manual provides instructions and information
required to operate the ACE series on-car disc brake
lathe.
This manual assumes that the technician is familiar with
the basics of brake service. Section 1 provides mechani -
cal and electrical safety information, specifications, as
well as general information about the ACE. The following
sections contain detailed information about equipment,
procedures, and maintenance.
The owner of the lathe is solely responsible for arranging
technical training. Only qualified Hunter trained techni -
cians should operate the lathe. Maintaining records of
personnel trained is solely the responsibility of the owner
or management.
This On-Car Disc Brake Lathe has been
designed to machine disc brake rotors on
passenger cars and light trucks. Use the lathe
only for its intended purpose as outlined in
this manual.
California Warning: This product may contain
chemicals known to the State of California to
cause cancer and reproductive harm.
www.P65Warnings.ca.gov