Hunter AutoComp Elite, Operation Instruction Manual, Page: 22 / 33

18 OPERATION INFORMATION
Figure 43
8. Determine depth of cut: the current rotor thick -
ness is displayed as “thickness”. These measure -
ments will update as the adjustment knob runs the
bits in or out. Remaining thickness is displayed right
of thickness. Green indicates an acceptable cut, yel -
low; warning approaching minimum rotor thickness,
Red; below rotor thickness: discard rotor
.
Figure 44
9. Push START when ready to cut.
10. Repeat process for Rear rotors.
The values used to determine
these warning levels are change -
able via Setup under Digi-Cal.
You can also disable these indica -
tors as well. Service Mode is
required for these.4.There is an
"I" (Information) icon next to the
Remaining box. The user can
press this to find out if the
Remaining value is being com -
pared to either the Min Machine
spec or the Discard spec (both of
which are shown in the Vehicle
Specifications screen).