Hunter AutoComp Elite, Operation Instruction Manual, Page: 32 / 33

2
6. Select additional vehicle identification information if required.
7. Digi-cal provides specs, including adaptor, min rotor thickness and discard thickness, lug nut
size, and torque.
Figure 3:
8. Determine depth of cut: the current rotor thickness is displayed as “thickness”. These mea -
surements will update as the adjustment knob runs the bits in or out. Remaining thickness is dis -
played right of thickness. Green indicates an acceptable cut, yellow; warning approaching
minimum rotor thickness, Red; below rotor thickness: discard rotor
.
Figure 4:
9. Push START when ready to cut.
10. Repeat process for Rear rotors.
i
The values used to determine these warning levels are changeable via
Setup under Digi-Cal. You can also disable these indicators as well. Ser -
vice Mode is required for these.4.There is an "I" (Information) icon next to
the Remaining box. The user can press this to find out if the Remaining
value is being compared to either the Min Machine spec or the Discard
spec (both of which are shown in the Vehicle Specifications screen).