Hunter 50CC, Operation Manual

Page: 86 / 200

Hunter 50
CC
• Underwater Gear
6.6
this maintenance follow all safety procedures and com-
plete the following:
Using the emergency handle, unscrew the nut by
turning the handle counterclockwise.
Remove the drum, upper cone, chain wheel, and
lower cone.
Wash down with water to remove any residue
Coat surfaces with a light film of lubricant
•
•
•
•
Reassemble the unit and tighten the clutch by turning
the handle clockwise.
Note: Refer to your Owner’s / Operator’s Manual in your own-
er’s kit for detailed information about your windlass.
6.4.2 Anchor
Your Hunter is equipped with a Danforth type anchor
well and drain and a Danforth type anchor as standard
equipment. The anchor is selected to suit the size and
weight of your boat under normal anchoring condi-
tions, and is most effective in muddy or sandy bottoms.
Fig. 6.10 will show you the details of the windlass and
anchoring system in illustrated detail, showing the plan
view.
Fig 6.11 shows you a profile view of the anchoring, and
windlass system. This illustration shows the smaller and
the larger anchor well, in relation to the location.
WARNING
! !
Anchoring in unusual water, and or weather condi-
tions will require additional precautions. Consult an
approved guide for suggestions.
•
Fig. 6.10
Fig. 6.11
PLAN
PLOW ANCHOR
ANCHOR RODE
(CHAIN OR ROPE OR COMBO)
TYPICAL CLEAT
LOCATIONS VARY
W/MODEL.
STAINLESS BOW ROLLER
(SIZE & SHAPE VARIES
BETWEEN MODELS)
NOTE: THE FORWARD "U" BOLT IN THE ANCHORWELL IS CONSIDERED THE
STRONG POINT. THAT SHOULD BE USED IF THE VESSEL IS TO BE TOWED
NOTE: ALWAYS SECURE ANCHOR RODE TO THE CLEAT OR
LASH ANCHOR SECURE TO BOW ROLLER IN ADDITION TO
THE QUICK PIN.
ELEVATION
WELL: SMALLER MODELS
WATERLINE
WELL: LARGER MODELS
STAINLESS BOW ROLLER