Hunter 50CC, Operation Manual

Page: 18 / 200

Hunter 50
CC
• Documents and Forms
2.4
Preliminary care and maintenance checklist
A qualified Technician should be used if you are not completely confident in your ability to
make repairs or inspections.
Out of Water Inspection
Pre-launch inspection
____ Sacrifi cial zinc anodes installed
____ Propeller installed with keyway, nuts and cotter pin
____ Propeller shaft turns freely and without excess wobble
____ Struts and shaft log free of corrosion
____ Rudder swings easily & correct with wheel direction
____ Rudder and post inspected for cracks and/or concealed damage (may require removing rudder)
____ Auxiliary tiller handle properly aligned, fi ts securely and operational
____ All thru-hulls and valves below water line inspected for corrosion, labeled and closed until after launch
____ Bottom paint in satisfactory condition
____ Hull freshly cleaned and waxed (free of gelcoat damage)
____ Mooring, safety lines and fenders onboard and in good condition
____ House & engine start batteries installed and fi lled with correct electrolyte levels
____ House & engine start battery boxes secured
____ All battery terminals clean and wires secured
____ Engine block & transmission drains closed
____Speed / Depth transducers in place. Speed paddle wheel rotates smoothly
____ Hose clamps on all systems below water line tight
____ Keel bolts tight and clean
____ Exhaust hose attached and secured
____ Boat is free of internal and external water leaks above water line
(Failure to stop water intrusion could result in permanent damage or deterioration of structural coring materials, internal wiring and cause mildew and molding)
Mast Assembly
____ Review manufacturers manual for maintenance and up-keep
____ Spreaders securely fastened
____ Mast and spreaders free of corrosion and stress cracks
____ Standing rigging and pins inspected for wear, tear, corrosion and cracking
____ External wiring secured for anchor, steaming and deck lights
____ Electronic wind indicator installed per manufacturers recommendation
____ Manual wind indicator installed on masthead
____ VHF antenna installed and connected
____ Headsail furling system installed inspected per manufacturers recommendation
____ Running rigging inspected for wear and tear
____ Mast step stand-up blocks secured and operational
____ Main Sail, jib sail and fl aking system inspected for wear and tear (non-furling mast).
____ In- mast system checked for smooth operation and overall condition of sails
____ Specifi ed pre-bend and diagonal tensions attained in mast. See owners manual
____ Mast to deck wiring properly sealed with drip loop