INSTALLATION
18
Complete the Installation
Remove the Covering from the Headrail
■
Gently peel the clear covering from the fabric-covered headrail.
Inspect the Folds
■
If the first fabric fold does not hang as well as others, see “Troubleshooting” on page 22.
Perform the Final Cord Adjustment
■
Open and close the fabric panel(s) several times.
■
To make final cord adjustments, loosen and re-tighten the cord anchors one at a time.
➤
Gently pull the cords until you feel a slight resistance. Do not over-tension.
■
Again, open and close the fabric panel(s) several times. The rails should slide easily, yet hold
their position anywhere along the headrail.
■
Re-adjust the cords as needed. Increase tension in the cords if the rails do not hold their
position. Reduce tension in the cords if the rails are difficult to move.
Attach Magnetic Hold-Down Brackets (Optional)
Magnetic hold-down brackets hold the secondary rail(s) flush with the end of the headrail.
■
Determine where to attach the hold-down brackets.
➤
Outside mount:
Slide the secondary rail to the end of the headrail. Mark the edge of
the rail on the mounting surface. Slide the rail away from the end of the headrail and
measure
3
/
4
" in from your mark (toward the shade). Mark this location.
➤
Inside mount:
Slide the secondary rail to the end of the headrail. Mark the rear edge of
the rail on the jamb. Slide the rail away from the jamb and measure
3
/
8
" back from your
mark (toward the glass). Mark this location.
3
/
4
"
Edge of
Secondary
Rail
Hold-Down
Bracket
Centerline
Outside Mount
3
/
8
"
Rear Edge of
Secondary
Rail
Jamb
Wall
Hold-Down
Bracket
Centerline
Inside Mount
Summary of Contents for Vignette EasyRise
Page 47: ......
