11
Installing the ICE Mount
Fully Assembled MEGA 360 ICE
4. Install the Heading Sensor
1. Thread the MEGA 360 cables up through the heading sensor mount.
2. Position the heading sensor mount at the top of the pod shaft.
3. The mount should be aligned so the opening for the cables is toward the back
of the MEGA 360 Imaging pod.
4. Secure the heading sensor mount with one 1/4 - 20 screw and one 1/4 - 20
hex nut through the stem.
5. Route the MEGA 360 cables through the opening of the heading sensor
mount and hold them in place.
6. Position the sensor so that the arrow on the cover is parallel with the front of
the transducer (rounded part).
7. Attach the heading sensor to its base using the two #8 - 32 x 1 1/4" screws
and two #8 -32 hex nuts.
NOTE:
Failure to align the sensor correctly will result in incorrect compass readings.
Installing the Heading Sensor
