6
532821-2_A
ICE HELIX® SERIES
Installation Guide
6. Install the screws in the holes on the bottom of the tray. Hand-tighten only. See the illustration
Removing the Screws
to replace the screws.
7. Turn over the cable tray so the Humminbird log is facing up.
Confirm the cables hang straight, and untwist them if necessary.
8. Line up the slots on the cable tray with the matching ports on the back of the control head. Line
up the cable tray pins with the holes on the control head.
9. With the Humminbird logo facing up, plug the cable tray into the back of the control head. The
cable tray clasps should click into place. See the illustration
Connecting the Cable Tray to the
Control Head
.
Connecting the Cable Tray to the Control Head
10. Pull carefully on the cable tray to confirm the installation is secure.
11.
Remove the cable tray (optional):
Squeeze the sides of the cable tray until it releases.
Mount the control head
1. Place 1 rubber washer onto each gimbal knob.
2. Install the gimbal knobs (with washers) into each side of the control head. Tighten the knobs
just enough so you can slide the control head into the gimbal bracket arms.
3. Slide the control head into the bracket.
4. Adjust the control head viewing angle as needed, and tighten the gimbal knobs until the
assembly is secured.
Hand-tighten only!
5. Pass any excess cabling back through the cable pass-through window and cinch the cover.
Assembling the Control Head and Bracket
Turning over the Cable Tray
cover
Removing the Screws
COM
(communications)
transducer
power
Ethernet
pin
pin
NMEA 2000
power
transducer
cable
groove
power connector
notch facing up
Locating the Cable Tray Slots
Inserting the Cable Connectors
into the Cable Tray
