2
532821-2_A
ICE HELIX® SERIES
Installation Guide
2
|
Testing the Transducer
Prior to installation, test the transducer to make sure that no damage occurred during shipping.
1. Connect the power cable to the control head and the battery terminal adapter (see
Installing
the Battery and Connecting Power
).
2. Connect the transducer cable to the control head (see
Installing the Transducer
).
3. Lower the transducer into the ice hole.
4.
Power On:
Press the POWER key. While the Title screen is shown on the display, press the MENU
key. Select Normal mode, and press the RIGHT cursor key to start Normal mode.
If the transducer is working properly, you will see the bottom on the sonar view.
5.
Power Off:
Press and hold the POWER key.
6.
Disconnect Cables:
Disconnect the transducer and power cable from the control head.
Disconnect the power cable terminals from the battery until the installation is completed and
you’re ready to fish.
ICE HELIX Series Shuttle Assembly
Perform the ICE HELIX shuttle assembly tasks in order, referring to the step-by-step procedures.
When you are finished, the control head and the transducer will be part of the ICE shuttle assembly,
and you will be ready to take your ICE HELIX out on the ice for final setup.
1
|
Assembling the Shuttle
1. Insert the handle into the two openings on each side of the shuttle base. The metal power
switch frame should be oriented to the right side of the base. Push down on the handle so that
it is fully inserted.
2. Secure the handle to the base using the two included 1/4 - 20 x 5/8" screws, one on each side.
See the illustration
Installling the Handle onto the Base
.
Hand-tighten only.
3. Insert the power switch and backbone into the power switch frame from the front of the handle.
The switch should be facing the rear of the shuttle base.
4. Fasten the switch to the frame using the two included #8 – 32 x 3/8" screws. See the illustration
Installing the Power Switch
.
Installing the Power Switch
power switch
and backbone
Installing the Handle onto the Base
