version 1.2_en
page 15
Changing the sensor
Plug in the desired sensor (if necessary screw off the other sensor before).
The device automatically recognizes which sensor is active and provides the
corresponding calibration curves.
Info: using 2 sensors at the same time is not possible!!
Changing the sensor in detail:
If an external sensor is mounted, screw off this sensor and put it into the
plastic case again. If no external sensor is plugged in, the internal building
moisture sensor with its corresponding calibration curves is active. When
plugging in a sensor, please pay attention to the polarity. The female and the
male connector have a notch (resp. a lug) which allow the plugging in only in
the right position. The sensor must not be plugged in by force. This may cause
mechanical resp. electrical consequential damages. Take care that the
external sensors are fixed strongly. The sensors are not waterproof. Protect
the sensors from strong dust exposure.
USB connector
sensor connector
