Huka Skwirrel II, Service Manual

Page: 16 / 74

16
step 7.
Replace the tyre and tube (or the solid tyre).
step 8.
Place both rim parts back on to the tyre. Make sure you line
out the valve opening of the rim.
step 9.
Tighten the five bolts on the rim. After doing this pump up the
tyre up to 2,5 Bar pressure. If the tyre is solid you only need
to tighten the five bolts.
step 10.
Place the wheel back on to the rear axle. Before doing this,
put al little grease on to the axle to prevent it from corrosion.
Tighten the M8 nut.
WARNING:
Don’t tighten the nut to hard. If it tightened to hard the
ball bearings might get damaged. Make sure the
wheel rotates easily