Hughes NH9000, Installation Manual, Page: 35 / 126

explanation, click the state code. For additional information, see Table 17: State codes on
page 79.
Note: Do not change the Antenna Pointing Indicator Delay value.
6. Click Submit Installation Parameters .
The modem saves the information you entered to flash memory. If you enter a new parameter
or modify a parameter, the modem reboots. After the reboot, the Terminal Pointing Info
screen appears. See
Figure 16: Terminal Pointing Info screen on page 21.
Figure 16: Terminal Pointing Info screen
If you want to change any of the values you previously entered on the Installation Parameters
screen, click
Modify Installation Parameters . This returns you to the Installation Parameters
screen.
Do not click the Abort Pointing button. This would skip the pointing phase and subsequently
cause registration to fail. Then you could only register the modem by obtaining a pointing
override from the NOCC. The
Abort Pointing button is used only during manual IDU
(modem) replacement, for which the NOCC explicitly approves an antenna pointing override
for the site.
Note: At this point, prior to antenna pointing, the SQF value may be 0, indicating that
the demodulator is initializing, or 1, indicating that the demodulator is searching for a
beacon signal. Most of the time the SQF value is 1 until the demodulator acquires the
beacon signal; then it is > 1.
7. Make a note of the values shown in the
Computed Parameters
area of the Terminal Pointing
Info screen:
• Azimuth
• Elevation
• Tilt angle
• ODU polarization setting (LHCP or RHCP)
21
HN9000 Satellite Modem Installation Guide
1037576-0001 Revision G
Chapter 3 Installing the satellite modem