Figure 30: Terminal Connectivity Test page
2.
Click
Start Test
.
You may see a screen that asks you to wait while the test is conducted. When the test finishes,
the Connectivity Test results page appears.
Figure 31: Connectivity Test results page
If the number of messages sent equals the number of messages received, the test is
successful—there is good connectivity between the remote router and the satellite.
If the number of messages received is greater than zero but not equal to the number of
messages sent, you have physical connectivity to the satellite, but if this test result persists,
you may have an access problem.
Typically the delay time (time message is sent until it is received) is approximately 1 second.
The screen shows the minimum, average, and maximum delay times for the test messages
in milliseconds. Most important is whether all messages are received or not.
For additional information, see
How to interpret these results
on the test results page.
HN9500 Satellite Router User Guide
50
1037737-0001 Revision E
Troubleshooting
Chapter 5