Using the LCD and Keypad
3500988-0001 Revision A
19
Exit Pointing and Registering with the network
Once you have accurately pointed the unit to the satellite, exit
pointing by a long press of the Back button. This will cause the
unit to attempt to register with the BGAN network (note: if
audible pointing tones were enabled during pointing, they will
automatically turn off once you attempt to register).
Idle mode display
Once the unit exits pointing, it will automatically attempt to
register with the network. During this operation it displays
“Registering” on the upper line of the LCD.
Once it registers and is ready for PDP contexts, it displays
“Ready” on the upper line.
Once it is ready for voice calls, it displays the globe icon (see
below).
If user equipment is connected (via Ethernet or Wireless LAN),
the lower line will display “ADDR:” plus the last octet of the IP
address of the currently selected user terminal. If multiple
devices are attached, you can select the others by pressing the
user button.
The signal quality is shown as a number in the right corner of the
lower line; typical values in idle mode are 56 to 60.
Connection mode display
When a PDP context is active, the type of connection is
displayed on the upper line: “Standard”, “Stream 32k”, etc.
The lower line displays the “ADDR:” information and the
current signal level as described above.