Front Wheel
NOTE:
If the bicycle does not have a front fender, go
to Step 2.
Step 1:
If the bicycle has a front fender, attach
it to the fork as shown.
Locate the fender in the fork with the upper
fork mounting tab on the rear side of the
fork.
Insert the fender screw (1) through the fork,
the washer (2), and the fender tab (3) - from front
to rear . (If the bicycle has a front brake
install the upper fender tab on the brake mounting
stud.)
Install the Nylock nut (4) on the screw and
tighten the assembly.
Insert each lower mounting screw through
the fender brace, and into the lower fork
mounting tab.
Tighten each screw sufficiently to hold the
fender in-place, be careful not to over tighten
and strip the screw threads.
Step 2:
Assemble the front wheel to the fork as shown:
- Make sure the tab of each wheel retainer [6] is in the
hole of the fork
NOT
E: Some models have a front fork with a built in
wheel retention feature. (As shown in the lower
mounting screw photo.) The wheel retainers [6] are
not required and will not fit on a fork with this feature.
- Using the two nuts [7] with serrations [8], attach the
front wheel
WARNING:
Do not use the nuts without
serrations to attach the front wheel.
- Put the wheel in the center of the fork and tighten both
nuts to the recommended torque of 21 ft.-lbs.
Fully Assembled
Upper Mounting Screw
Lower Mounting Screw
