Seat
Assembly
If the seat does not come pre-assembled to the seat post,
assemble the seat to the seat post: as shown:
- Make sure the seat post [10] is fully through the seat clamp [11]
- Tighten the seat clamp so the seat [12] stays on the seat post.
- If the seat clamp has a nut on each side, tighten both
nuts equally.
If the bicycle has a seat post bellows or seat post tights
[13], push the bellows or tights fully onto the seat post.
NOTE:
If necessary, push the bellows or tights together
so you can see the “MIN-IN” mark [15] on the seat
post.
Point the seat forward and put the seat post into the seat tube.
Put the seat and the red reflector in the correct position
and tighten the post clamp or quick-release lever:
- Put the seat at a comfortable height for the rider
Assemble the seat to the seat post or seat pillar:
The bicycle may have a seat post or seat pillar. Determine which style you have and follow the instructions.
Seat Post Style
- Put the seat post [10] fully through the seat clamp [11]
- Tighten the seat clamp so the seat [12] stays on the seat post
- If the seat clamp has a nut on each side, tighten both nuts equally
Seat Pillar Style
- If the seat has a clamp attached, remove and discard the clamp
- Put the seat rails between the seat clamp and tighten the clamp.
Point the seat forward and put the seat post or seat
pillar into the seat tube.
- Make sure you can not see the “MIN-IN” minimum
insertion mark [13] of the seat post above the seat tube
- Install a bolt, washer (if supplied), and nut or a quick release
lever
- Put the seat at a comfortable height for the rider
WARNING:
The red reflector must be vertical, point straight toward
the rear of the bicycle, and have three inches of clearance between the top
of the seat and the top of the red reflector.
- Tighten the bolt and nut or quick release lever
