Front Reflector Bracket Installation
This section covers several different placements of the front reflector bracket. Make sure the front
reflector is vertical (perpendicular to the ground).
The front reflector bracket will mount on the fork or handlebar. Some models may already have the
brackets and reflectors installed. If the reflector is not installed, refer to the “Front Reflector Bracket
and Clear Reflector Assembly” section.
Determine which type of reflector bracket you have and its mounting location and then follow the
instructions for that style.
Top of Fork
Bottom of Fork
Handlebar Mount
Handlebar Mount
Style 1
Style 2
Top of Fork
Attach the hardware to the fork:
- Remove and discard plastic cap [5] (if installed) on fork [6]
- Tighten bearing cone [7] by hand to make sure the bearings are tight
- Install reflector bracket and locknut [8]
- Tighten locknut.
Bottom of Fork
Attach the hardware to the fork:
- Remove and discard plastic cap [5] on fork [6]
- Tighten bearing cone [2] by hand to make sure the bearings are tight
- Install sheath stop [3] and locknut [4]. You may not have a sheath stop. If you do not, install a keyed
washer and locknut.
NOTE:
The sheath stop barrel [11] is on the cable wire of the front cantilever brake. Install it during the
assembly of the brake.
- Tighten locknut.
Assemble the front reflector bracket and clear reflector to the fork:
- Attach the reflector bracket to the front of the fork with a bolt [9] and self locking nut [10]
- If necessary, adjust the angle of the front reflector bracket so the clear reflector is vertical (perpendicular
to the ground).
