Pad Sets:
Assemble the pads in the correct location as shown.
- Attach with the sewn in hook & loop fasteners.
WARNING: Failure to install properly could result
in serious injury.
Doll Carrier Installation
The Rear Bracket is installed on the bike at the factory.
The Front Bracket is in the parts bag, parts box, or handlebar bag.
Installation:
•
Loosen the rear axle nuts enough so that the rear bracket can rotate. Do not remove the axle nuts.
•
Remove the carrier mounting screw/nut assembly from the seat stay cross brace.
•
Remove the 2 rear carrier mounting screws from the rear bracket.
•
Mount the front bracket as shown.
Do not tighten the screw at this time
.
•
Place the carrier onto the front bracket.
•
Align the 2 slots in the bottom of the carrier, the 2 holes on the front bracket, and the 2 threaded holes
in the rear bracket.
•
Install the 2 screws through the carrier, front bracket, and thread them into the rear bracket.
Note: Do not over tighten the screws – this can damage the plastic carrier.
•
Tighten the front bracket screw.
•
Tighten the rear axle nuts.
WARNING
: THE AXLE NUTS MUST BE SUFFICIENTLY TIGHTENED TO ENSURE THEY DO
NOT COME LOOSE.
WARNING
: THE DOLL CARRIER IS FOR TOY DOLLS ONLY. MAXIMUM WEIGHT IS 5 LBS.
