17
MAINTENANCE SCHEDULE CHART
Service Recommendations for Hud-Son Sawmills
Service Item
Daily
40
Hours
See
Manual
Check Engine Oil Level
Check/Clean Engine Air Filter
Check Hydraulic Oil Level (fill 1” from top) if applicable
Clean Unit of Bark, Saw Dust, and other Debris
Lubricate Grease Fittings and Oil Points (see Diagram for locations)
Check Tire Pressure - Upon transport (if applicable)
Check Cylinders and Seals for Leakage
Check Feed Chains for tension (if applicable)
Clean Battery Connections
Check Wiring and Connections for Corrosion and Decay
Lubricate Chains (if applicable)
Check Blade Sharpness
Fuel - fill as needed
Blade Lubricant - fill as needed -
Refer to 2A on page 6
Check hoses/gauges for damage, cracks, leakage (chaffing, dry rot, cracks,
replace hoses if applicable)
* Change engine oil after 8
hours of operation on a new
engine (break -in period)
CAUTION!
Maintenance Procedures requiring special training or
tools should be performed by a trained technician.
A routine inspection of the entire machine is encouraged. Check to see if all fittings are
tight and secure. Make sure all nut are tightened. Check to see any damage that may need
to be repaired before and further damage occurs. Routinely checking the equipment and
proper maintenance will help in keeping the Hud-Son Saw Mill running to the best of its
ability.
