3.2 Pre-flight checklist
(1) Make sure the aircraft battery and mobile device are charged and have adequate power.
(2) Confirm that propellers and screws are properly installed.
(3) If you are taking pictures, insert the Micro-SD card required for taking pictures and videos.
(4) Verify that the motors arm and spin smoothly.
(5) Ensure the camera lens is clean.
12
High pressure lines
Rain
Magnetic interference
Airports
3.3.1 Binding the aircraft and transmitter
1. Pull and hold the throttle to its lowest position.
3.3 The first flight configuration: Ai HT015 Transmitter
2. Hold down the Photo key and power the transmitter on. The transmitter’s status LED will flash
red; please do not press or touch any other keys, buttons or sticks while this process is ongoing.
Users may let go of the Photo key and throttle. Connect the aircraft to its battery and allow it to
bind to the transmitter. The two must be very close to each other; when the bind is successful,
the binding status LED will turn green.
All illustrations are shown in Mode 2 (American hand)