21
port, the BNC end is connected to the ultrasonic sensor BNC port.
Two channels tester connection
2. Main tester settings
Open the main tester, Press CH1 to select the current channel at channel 1,
then press” Menu” key and F1 key to set “ discharge test” as TEV, Press F2 key to set
“ output voltage” and “ unit”. Use the composite TEV sensor for testing shall set the output
voltage.
Press CH2 to select current channel at Channel2, then press” Menu” key and F1 key to
set “ discharge test” as USS. Press F2 key to set ”output voltage” and “Unit”.
Use the ultrasonic sensor for testing shall set the output voltage.
3. Start measurement
Press” AUTORANGE” Key till the light is on to green, then the tester is about to measure.
AUTORANGE Open