huawei(config-if-gpon-0/1)#
ont alarm-profile 1 1 profile-id 1
huawei(config-if-gpon-0/1)#
ont alarm-profile 1 2 profile-id 1
6.
Confirm that the ONT goes online normally.
After an ONT is added, run the
display ont info
command to query the current status
of the ONT. Ensure that
Control flag
of the ONT is
active
,
Run State
is
online
,
Config state
is
normal
, and
Match state
is
match
.
huawei(config-if-gpon-0/1)#
display ont info 1 1
---------------------------------------------------------------------
F/S/P :
0/1/1
ONT-ID :
1
Control flag :
active
//Indicates that the ONT is
activated.
Run state :
online
//Indicates that the ONT goes online
normally.
Config state :
normal
//Indicates that the configuration status
of the
ONT is normal.
Match state :
match
//Indicates that the capability profile
bound to
the ONT is consistent with the
actual capability
of the ONT.
...//The rest of the response information is omitted.
If the ONT state fails, the ONT fails to be in the up state, or the ONT does not match,
check the ONT state by referring to the above-mentioned descriptions.
–
If
Control flag
is
deactive
, run the
ont activate
command in the GPON port mode
to activate the ONT.
–
If the ONT fails to be in the up state, that is,
Run state
is
offline
, the physical line
may be broken or the optical transceiver may be damaged. You need to check both
the material and the line.
–
If the ONT state fails, that is,
Config state
is
failed
, the ONT capability set
outmatches the actual ONT capabilities (For details about the ONT actual
capabilities, see Reference of GPON ONT Capability Sets. In this case, run the
display ont failed-configuration
command in the diagnosis mode to check the
failed configuration item and the failure cause. Then, rectify the fault according to
actual conditions.
NOTE
If an ONT supports only four queues, the values of 4–7 of the priority-queue parameter in the
gem add
command are invalid. After configuration recovers, Config state will be failed.
–
If the ONT does not match, that is,
Match state
is
mismatch
, the port types and
number of ports undermatch the actual port types and number of ports supported
by the ONT. In this case, run the
display ont capability
command to query the
actual capability of the ONT, and then select one of the following modes to modify
the ONT configuration:
–
Create a proper ONT profile according to the actual capability of the ONT, and
then run the
ont modify
command to modify the configuration data of the ONT.
–
Modify the ONT profile according to the actual capability of the ONT and save
the modification. Then, the ONT automatically recovers the configuration
successfully.
7.
Configure a traffic profile.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
3 Configuration
Issue 04 (2011-01-12)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-125
