HT PVCHECK, Manual

Page: 50 / 56

PVCHECK 48
8. CONNECTING THE INSTRUMENT TO THE PC
CAUTION

The connection between instrument and PC is realized by means of cable C2006.

In order to transfer the data onto a PC it is necessary to install beforehand both the
management software Topview and the drivers of cable C2006 on the PC itself.

Before connecting, it is necessary to select the port to be used and the correct baud
rate (57600 bps) on the PC. To set these parameters, launch the TopView software
provided and refer to the programme’s on-line help.

The selected port must not be engaged by other devices or applications, e.g. a mouse,
a modem, etc. Close any applications running using the Microsoft Windows Task
Manager function.

The optical port emits invisible LED radiations. Do not directly observe with optical
instruments. Class 1M LED apparatus according to standard IEC/EN 60825-1.
To transfer data to the PC, follow this procedure:
1. Switch on the instrument by pressing the ON/OFF key.
2. Connect the instrument to the PC via the provided optical/USB cable C2006 .
3. Press the ESC/MENU key to open the main menu.
4. Use the arrow keys (

,

)
to select “
PC
” to access data transfer mode and confirm with
ENTER .
5. The instrument shows the following screen: 6. The instrument shows the following screen:
7. Use TopView controls to activate data transfer (please refer to the on-line help of the
programme).
9. MAINTENANCE
9.1. GENERAL INFORMATION
The instrument you purchased is a precision instrument. While using and storing the instrument,
carefully observe the recommendations listed in this manual in order to prevent possible damage
or danger during use.
Do not use the instrument in environments with high humidity levels or high temperatures. Do not
expose to direct sunlight.
Always switch off the instrument after use. In case the instrument is not to be used for a long time,
remove the batteries to avoid liquid leaks that could damage the instrument’s internal circuits.
9.2. BATTERY REPLACEMENT
When the low battery symbol “ ” appears on the LCD display, or if during a test the
instrument shows the message “low battery”, it is necessary to replace the batteries.
CAUTION
Only expert and trained technicians should perform this operation. Before carrying out
this operation, make sure you have disconnected all cables from the input terminals.