![background image](http://html1.mh-extra.com/html/ht/pqa400/pqa400_user-manual_2178122060.webp)
PQA400 - PQA823 - PQA824
EN - 59
2. Use up or down arrow keys or press F3 or F4 keys (alternatively touch the MOD(+) or
MOD(-) s at display) to set the correspondent value. Pressing and holding of these
keys permit a rapid values setting, while the single pressure increase or decrease on
only unit the value.
3. Press SAVE or ENTER keys (or the smart icon
) to save each performed setting.
5.4.12. Predefined configurations
In order to make the recording start easier the meter includes 5 selectable predefined
configurations which describe typical situation in electrical installations, besides a “Default”
configuration which defines the initial settings from the factory. The meter also permits to
define up to 14 free configuration which can be customized, saved and recalled by user
at any time. The selection of one of these configurations automatically sets only the
necessary parameters for recording operation under that circumstance. The predefined
configurations are:
1. DEFAULT: Setting parameters of default configuration from the exit of meter by
factory.
2. EN50160: Setting parameters for networks quality recording (voltage anomalies,
harmonics, flicker, unbalance and spikes) in compliance to EN 50160 standard (see §
10.2.2).
3. VOLTAGE ANOMALIES: Setting parameters for voltage anomalies recording only
(sags, swells, breaks – see § 10.1).
4. HARMONICS: Setting parameters for voltages and currents harmonic analysis (see §
10.2).
5. INRUSH: Setting parameters inrush current events detection.
6. POWER & ENERGY: Setting parameters for power and energy measures (see § 10.7).
Pressing F2 key (or touch PREDEF. at display) in any “Recording Settings” screen. The
meter show the below screen:
12/09/2006 – 16:55:10
PREDEFINED CONFIGURATIONS
Typical Configuration
DEFAULT
EN50160
VOLTAGE ANOMALIES
HARMONICS
INRUSH
POWER & ENERGY
ADD
REM
Fig. 112: Typical configuration screen
Select the desired typical configuration using up or down arrow keys or touch display.
Press SAVE or ENTER keys (or the smart icon
) to save the desired selection. The
warning message ”Change recording setting?” is shown by meter. Press “Ok” to confirm.
The meter automatically sets the parameters and updated the recording autonomy at
display.
To add a predefined customized configuration press the F1 key (or the ADD at display).
The warning message “Add actual configuration” is shown by meter. Press “Ok” to
confirm and activate automatically the virtual keyboard (see § 5.4.2.1) where it’s possible
Shop for HT products online at:
1.877.766.5412
www.
PowerMeterStore
.com