I-V400w - I-V500w - SOLAR I-Vw - SOLAR I-Ve
EN - 52
9. Connect irradiance probes and temperature probe (if necessary) according to previous
pictures and to effected settings (see § 6.3.2).
10. In the initial screen of
IVCK
mode
the following values are
displayed:
Module under use
Irradiance (through direct measurement or SOLAR_02 under
RF connection)
The temperature value (if mode MAN or AUX) and
corresponding measurement mode. If mode AUTO
”- - -“
The average values of Voc and Isc under OPC conditions
The following values acquired in real time are also displayed:
Open circuit voltage
Any symbol of RF connection with SOLAR-02
15/05/10
15:34:26
M o d u l e :
S U N P W R 2 1 0
I r r . 9 8 0 W / m 2
T c ( A U T O )
- - ° C
V o c M e d @ O P C
6 4 7
V
I s c M e d @ O P C
5 . 4 3
A
V o c @ O P C
6 4 6
V
I s c @ O P C
- - -
A
V o c @ S T C
- - -
V
I s c @ S T C
- - -
A
Selection
I V C K
CAUTION
When pressing the
GO/STOP
key the instrument can provide different error
messages (see §6.3) and, as direct consequence, not carry out the test. Check
and eliminate, if possible, causes of the problems before continuing the test.
11. Press
GO/STOP
(in Manual activation mode) to start up the
test. In case of no error conditions, the instrument displays
the screen with the following results:
The module under use
The irradiance value
The cell temperature value
The average values of Voc and Isc under OPC
The values of Voc and Isc measured under OPC
The values of Voc and Isc measured under STC and relative
partial outcome resulting after comparing the rated values.
15/05/10 15:34:26
M o d u l e :
S U N P W R 2 1 0
I r r 9 3 2 W / m 2
T c ( A U T O )
5 7 ° C
V o c M e d @ O P C
6 4 7
V
I s c M e d @ O P C
5 . 4 3
A
V o c @ O P C
6 4 7
V
I s c @ O P C
5 . 3 5
A
V o c @ S T C
7 8 7
V O K
I s c @ S T C
5 . 7 2
A O K
OUTCOME: OK
Selection
I V C K
In general:
4%
Isc
Tol
100
if
4%
Voc
Tol
100
if
@
@
@
@
@
@
@
@
STC
STC
STC
STC
STC
STC
STC
STC
IscNom
Isc
IscNom
OK
Isc
Outcome
VocNom
Voc
VocNom
OK
Voc
Outcome
The rated values of Voc and Isc are the values of the DB built-in modules (see §5.3)
The overall value of outcome:
o
OK: if all results under STC are OK,
o
NO if one of the results under STC is NO
12. Press
SAVE
to store the test result into the instrument’s memory (see §7.2) or press
ESC/MENU
to quit without saving and go back to main measurement screen
13. The “
Auto
” activation mode require to disconnect and reconnect the test leads in order
to start automatically a new measurement