11/2012
SP 4040
37
SP 4040
If you need to adjust the chain tension on a FA 400.2:
- Remove the cover plate on the right hand side
- Loosen the nuts and push the motor with the tensioning screws until the chain sag is
between 4 – 10 mm
- Tighten the nuts again
- Mount the cover plate and the loading table onto the unit again.
Note
Do not tighten the chain too much as this will wear the chain and the
bearings faster than would otherwise be the case.
The chain sag should be 4 – 10 mm.
5.3.2
Checking chain tension (2 x annually) FA 400.2
-
Switch off the shredder at the main switch.
-
Pull out the mains plug.
-
Remove the tray and the cover plate on the left hand side
