RevE 18/02/14
17
Operating the Appliance
F
ULL OPERATING INSTRUCTIONS ARE GIVEN IN THE
U
SER
I
NSTRUCTIONS
.
Fitting the Remote Control (Optional)
Fitting the Motor to the
Valve
Un-screw the cover retaining screw
with a small Philips screwdriver
(Shown in diagram 18). Prise off the
cover at the snap connection with a
small flat-bladed screwdriver
located on the right hand side of the
valve.
Turn the main burner
control knob (Knob ‘B’ –
diagram 19) fully anti-
clockwise until the end stop
is reached.
Fit the motor as shown in diagram
20, making sure that the motor sits
on the locating pin.
Replace the valve cover and
tighten the Philips headed screw.
(Do not over-tighten the screw as
this may effect the operation of
the control). Make sure that the
snap connector has located
properly. When fitted correctly,
the valve cover holds the motor
in the correct position.
Diagram 18
Diagram 19
Diagram 20
Knob B
Motor
Diagram 20