RevE 18/02/14
9
3. The mains supply pressure coming into the appliance can also be
checked by using Test point ‘B’, shown in diagram 10.
INSTALLATION OF THE FIRE-BED INTO THE
STOVE
IMPORTANT NOTE!!
CERAMIC COALS AND LOGS GET VERY HOT! NEVER ATTEMPT TO
HANDLE HOT COALS OR LOGS WITH BARE HANDS AND NEVER PLACE
HOT COALS OR LOGS ON OR NEAR COMBUSTIBLE SURFACES.
NO RESPONSIBILITY FOR ANY INJURY HOWEVER CAUSED WHILST
HANDLING HOT COALS, LOGS OR CERAMICS CAN BE ACCEPTED BY HS
GAS.
FIRE-BED ARRANGEMENT
This appliance can be fitted with either a ‘coal effect’ or a ‘log effect’
ceramics. If you are fitting ‘Coal’ ceramics please follow the
instructions set out in ‘Section A – Fitting the Coal Ceramic Matrices’. If
you are fitting ‘Log’ ceramics please skip ‘Section A’ and follow the
instructions set out in ‘Section B – Fitting the Log Ceramic Matrices’.
Burner Pressure Test Point
(Test Point ‘A’)
Mains/Supply
Pressure Test Point
(Test Point ‘B’)
Gas Supply Connection
(8mm Compression Fitting)
Diagram 10