RevE 18/02/14
14
Fitting the Loose Ceramic Logs
D.
Starting with the Y-shaped log, place
at the angle shown in diagram B11. The
bottom of the log should sit in the cleft on
the front ceramic matrix, with the flat
underside of it resting on the flat area on
the middle matrix. Of the longer 2
branches, the tip of the right hand
branch should rest in the left hand cleft
on the rear ceramic.
E.
The second log has two short
branches coming from it. It sits in the
furthest left cut-out on the front ceramic
and rests in the groove on the centre
ceramic, shown in diagram B12.
F.
The third log to be
placed is the thin ‘twig’.
The ‘twig’ is placed in the
cut-out between the first
two logs. The small
branch on the twig
should sit at an angle in
the cut-out , stopping the
twig falling between the
front and centre ceramic.
The top of the twig should
rest on the large log as
shown in diagram B13.
(Make sure that the
position of the twig does
not block any of the
burner ports.)
Diagram B12
Diagram B13
Diagram B11