4
Setup Instructions
The EXR Audio Stand System is a complete system that can be used with or without
HRS Isolation Bases. The components required to assemble the system are shipped
in one or more boxes. The number of boxes depends on the system size. Each box
containing parts for the system will be marked with the model number starting with
EXR. All the wrenches required to put the system together are included with the
shipment.
Work Surface
- Prior to unpacking any material, locate a very strong and very
stable work surface (capable of supporting 250 lb. load) or area on the floor that
will give you a very soft scratch resistant work area that is at least three feet by
three feet in size. The more space you have the better, as it will give you room to
move around the system to complete assembly. It is important that the area be free
of all dirt, screws or small pebbles, and that it is covered with a clean soft protective
blanket of same size that will prevent damage to high quality finish on the frame.
Unpacking Assembly Hardware
- Remove all the contents from all the boxes
marked with the EXR model number. Place all the hardware on a table adjacent to
your selected work surface and remove all the wrapping material. Be careful not to
drop or allow the anodized aluminum parts to contact each other as they may
scratch each other. Do not stack the parts on top of each other once they are
removed from the protective packaging material. To make assembly easier, group
identical parts together in an organized manner. Group all the struts by length.
This EXR audio stand system will be assembled upside down. Depending on what
system configuration you have purchased there will be a number of Frame Mounts
that have threaded caps already attached. Do not try to remove these threaded caps,
as they are bonded to the frame. These Frame Mounts with threaded caps will be
the top of the audio stand system.