－
10
－
4-3. Making preparation for crimping operation
4-3. 压接作业准备
CAUTION :
To protect against possible accidents due to abrupt start of the machine, start your work after
disconnecting the power to the main unit of the crimping machine.
* Be sure to check the crimping conditions (crimp heights) and crimping quality standards (crimp shape) in prior
to the preparation for crimping operation, while referring to the “Table of crimping conditions and the Crimping
quality standards” issued by us.
(1) How to conduct crimping operation
1) Set wire disk
1
, spacer disk
2
adjusting dial
3
and adjusting dial GT
4
as illustrated to the positions same as
shown in the sketch on the left (A-W-1-1).
2) Connect the power plug of the main unit of the crimping machine to the power receptacle and turn on the main
power switch.
3) Turn on the power switch mounted on the electrical box.
4) Lightly press the stripped end of the electric cable against wire stopper
5
at a position that is almost just above
the terminal.
(Caution) If crimping is carried out with the electric cable separated from wire stopper
5
or excessively
pressed against it, crimping quality deficiencies can result.
★
The top end of electric cable is as thin as AWG30, firstly press shoulder portion
6
of the electric cable sheath
against end face
7
of the terminal, then slightly draw the shoulder portion toward you to position the electric
cable.
5) Depress the foot switch.
Then, crimping performance is carried out by the up-and-down movement of the applicator ram every time the
ram unit of the crimping machine makes an up-and-down movement.
* 首先请确认压接条件 ( 夹紧高度 ) 和压接质量标准 ( 压接形状 )。( 请参照本公司印发的压接条件表、压接质量标
准书。)
(1) 压接作业方法
1) 请把线圆盘
1
、衬垫圆盘
2
、调整拨盘
3
、调整拨盘 GT
4
安装到左图所示的位置 (A-W-1-1)。
2) 请把压接机主机的电源插头插到电源插座上，然后打开 (ON) 主电源开关。
3) 请打开 (ON) 电气箱的电源开关。
4) 把剥皮后的电线前端轻轻地顶到线止动器
5
。
( 注意 ) 请不要让电缆离开线止动器
5
也不要向线止动器
5
顶得过强，否则会发生压接质量不良。
★ 电线的前端是 AWG30 那样的细时，请把电线被覆的肩部
6
顶到端子的端面部
7
之后，稍向前拉进行定位。
5) 请踩脚踏开关。
踩踏板之后，压接机凸轮部上下动作 1 次，供料器凸轮开始上下动作进行压接。
为了防止突然的起动造成事故，请关掉压接机主机的电源之后再进行操作。
注意
