HP Workstation x4000, Technical Reference Manual

Page: 175 / 238

Installing or Replacing Parts and Accessories
CD-ROM, CD-RW or DVD
Chapter 10 173
Figure 10-20 Removing the Old Drive
Installing a CD-ROM, CD-RW or DVD
To install an optical device:
1. Turn off the display and shut down the Workstation. Disconnect all
power cables and any LAN or telecommunications cables.
2. Remove the Workstation’s cover and front bezel (see page 145) for
instructions).
3. Remove the 5.25-inch metal filler plate from the chassis of the
Workstation by using your finger to pull the plate from the chassis.
4. Add the guide rails to the new drive. Refer to the sticker on the
Workstation chassis for the correct rails for your drive. Insert the
guide rails in the two holes located at the bottom of the drive. The
guide rails are not side-specific.
5. Align the guide rails on both sides of the drive with the internal shelf
guides, then slide the drive until it clicks into position. You should put
your Master device in the top bay and your Slave device in the lower
bay. For more information on Master/Slave configuration, see page
172.
6. Connect the power, data, and audio cables to the rear of the new
drive.
7. Remove the plastic cover piece from the Workstation’s bezel that
corresponds to your new drive before attaching the bezel and front
cover (see page 148).
8. Reconnect all the power and telecommunications cables.
Step 4
Step 3
This manual downloaded from http://www.manualowl.com