HP Workstation x2000, Getting Started Manual, Page: 16 / 76

Setting Up and Using Your Linux Workstation
Setting Up Your x2000 Linux Workstation
Chapter 1 16
Setting Up Your x2000 Linux Workstation
WARNING If you have any doubt that you can lift the Workstation and
monitor safely, do not try to move them without help.
1. When you receive your Workstation, verify that you have all of the
components as shipped.
2. Place the Workstation in an area with easily accessible power outlets
and enough space for the keyboard, mouse, and any other accessories.
3. Position the Workstation so that its rear connectors are easily
accessible.
Installation Tools
No tools are required to set up your Workstation. However, if you plan to
install or replace an accessory inside your Workstation, you will need a
T-15 Torx screwdriver and a flat-blade screwdriver.
Connecting Devices
Before connecting any cords or cables to your Workstation, please read
the Warning Notices in the Preface of this manual.
If you purchased a graphics card that was not installed in your
Workstation at the factory, you must install that card now. To install,
refer to the instructions that came with the card or see the x2000
Technical Reference/Troubleshooting Guide available at:
http://www.hp.com/workstations/support.