HP V1905 Series, Getting Started Manual

Page: 55 / 135

50
Item Description

Enabled: Enables the default path cost on the port. This is the default value.

Disabled: Disables the default path cost on the port.
Path Cost
Defines the port contribution to the root path cost. When Default Path Cost is
disabled, you can configure it; when Default Path Cost is enabled, you cannot
configure it. The possible field values are:

65535: Indicates Path Cost Default Values is short. This is the default value.

200000000: Indicates Path Cost Default Value is long.
Port Priority
Defines the priority value of the port. The priority value influences the port choice
when a bridge has two ports connected in a loop. The priority value is between
0-240. The default is 128.
RSTP Link Type
Specifies whether a Point-to-Point link is established, or if the switch is permitted to
establish a Point-to-Point link. The possible field values are:

No Change: Retains the current port status.

Auto: Enables the switch to establish automatically Point-to-Point link. This is the
default value.

Point to Point: Indicates if a Point-to-Point link is currently established on the port.
Ports set to Full Duplex modes are considered Point-to-Point port links.

Shared: Enables the switch to establish a shared link.
Viewing STP
The STP Summary Page displays the current STP parameters for all ports.
Click
Device

Spanning Tree

Summary . The STP Summary Page opens.
Figure 89 STP Summary Page
The STP Summary Page contains the following fields:
Table 71 STP Summary Page item description
Item Description
STP
Indicates if STP is enabled on the port. The possible field values are:

Enabled: Indicates that STP is enabled on the port.

Disabled: Indicates that STP is disabled on the port.