Edge Switch 2/24 installation guide
73
e.
Select
Enabled
or
Disabled
from the
Suppress RSCNs on Zone set activations
drop-down list.
The default state is disabled.
When the parameter is enabled, attached devices do not receive notification following any
change to the fabric's active zone set.
When the parameter is disabled, attached devices (registered through the fabric format
domain register) do receive notification following any change to the fabric's active zone set.
5.
Click
Activate
to save the information. The message
Your changes to the Operating
Parameters configuration have been successfully activated
is displayed.
6.
Set the switch online:
a.
Select
Operations
>
Online State
. The Operations page is displayed with the Online State
tab selected.
b.
Click
Set Online
. The message
Your changes have been successfully
activated
is displayed.
Set fabric parameters
The switch must be set offline to configure fabric parameters. To configure the parameters:
1.
Set the switch offline as follows:
a.
At the View window, select
Operations
at the left side of the panel. The Operations panel
opens with the Switch Beacon page displayed.
b.
At the Operations panel, select the
Online State
tab, then click
Set Offline
. The message
Your operations changes have been successfully activated
is displayed.
2.
At the View window, select
Configure
at the left side of the panel. The Configure panel opens
with the Ports page displayed.
3.
Click the
Switch
tab, then select the
Fabric Parameters
tab. The Switch page is displayed with
the Fabric Parameters options (
Figure 40
).
Figure 40
Switch page—Fabric parameters tab
