Removal and replacement procedures 44
c.
Finish the installation by completely tightening the screws in the same sequence.
6.
Install the air baffle.
7.
Install the access panel.
8.
Lock the tower bezel.
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Expansion board
To remove the component:
1.
Power down the server (on page
26
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Unlock the tower bezel.
4.
Remove the access panel ("
Access panel
" on page
31
).
5.
Remove the air baffle ("
Air baffle
" on page
32
).
6.
Disconnect all cables connected to the expansion board.
7.
Remove the expansion slot cover retainer.
8.
If removing a full-length expansion board, remove the board retainer securing it.
