Removal and replacement procedures 41
c.
Finish the installation by completely tightening the screws in the same sequence.
4.
Install the air baffle ("
Air baffle
" on page
32
).
5.
Install the access panel.
6.
Lock the tower bezel.
7.
Connect each power cord to the server.
8.
Connect each power cord to the power source.
9.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Processor
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
IMPORTANT:
If installing a processor with a faster speed, update the system ROM before
installing the processor.
To remove the component:
1.
Power down the server (on page
26
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Unlock the tower bezel.
4.
Remove the access panel ("
Access panel
" on page
31
).
5.
Remove the air baffle ("
Air baffle
" on page
32
).
