Hardware Options Installation
Installing a Tape Drive or Other Removable Media Device
All ProLiant ML310 server models ship standard with four removable media bays.
The top 5.25-inch bay is occupied by an IDE CD-ROM drive. The remaining three
5.25-inch bays are available for removable media devices. You can install three
half-height devices, or one full-height device and one half-height device, into these
bays.
NOTE: If installing an ATAPI tape drive, refer to “Cabling an ATAPI Tape Drive” in Chapter 4
for specific cabling information.
To install a tape drive:
Follow the procedures in “Preparing the Server” in this chapter.
2.
Configure the device.
— For SCSI devices, set the SCSI ID on the drive. You must manually set the
SCSI ID on each device to a unique value in the range of 0 to 6 for each
SCSI bus. Refer to the documentation provided with the device for
instructions on how to set the SCSI ID.
— For IDE (ATAPI or ATA) devices, be sure that the jumper on the drive is set
to Cable Select (CS) so that the drive device ID is determined by the cable.
Refer to Chapter 4, “Cabling Guidelines,” for further information.
HP ProLiant ML310 Server Setup and Installation Guide
3-17
HP CONFIDENTIAL
Writer: Ted Weiman File Name: d-ch3.doc
Codename: Son of Beast Part Number: 274431-002 Last Saved On: 11/22/02 1:58 PM
