HP ProCurve 5400zl Series, Installation And Getting Started Manual

Page: 67 / 135

3-7
Getting Started With Switch Configuration
Configuring the HP Wireless Edge Services zl Modules (J9051A, J9052A)
Getting Started With Switch
Configuration
Configuring the HP Wireless Edge
Services zl Modules (J9051A, J9052A)
Before beginning the configuration, backup the current configuration of the
switch.
The zl switch software must be updated to a version (K.12.40) that supports
the module. Visit
www.hp.com/networking/support to obtain a supported
version; to verify module support, refer to the version’s Release Notes .
The HP Wireless Edge Services zl Module (J9051A) and the HP Redundant
Wireless Services zl Module (J9052A) must be running software version
WT.01.xx or later.
N o t e
The term ‘module’ is used in this section to refer to both the HP Wireless Edge
Services zl Module (J9051A) and the HP Redundant Wireless Services zl
Module (J9052A).
There are four module configuration tasks required:
■ configuring an IP address for the module
■
configuring VLANs on the zl switch
■ determining a module configuration backup process
■ configuring wireless LAN services
Configuring an IP Address for the Module
By default, the module uses DHCP to get an IP address. The zl switch CLI has
a command context, the
wireless-services
context, for configuring and man-
aging a module.
N o t e
‘HP’ is used here as a generic prompt for all zl switches.
■
To identify the slot in the zl switch where the module is installed, enter
the following command:
HP# show modules
■ To show the module’s IP address, enter the following command to access
the module’s
wireless-services
CLI context for the module:
HP# wireless-services <slot-id>
where
<slot-id>
is the slot in the zl switch where the module is installed.