Reverse this procedure to install the processor.
Optical drive connector board
Description
Spare part number
Optical drive connector board (includes cable)
686899-001
Before removing the optical drive connector board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 48
), and then remove the following components:
a.
Hard drive (see
Hard drive on page 49
)
b.
Optical drive (see
Optical drive on page 53
)
c.
Keyboard (see
Keyboard on page 57
)
d.
Top cover (see
Top cover on page 66
)
Remove the optical drive connector board:
1.
Release the ZIF connector to which the optical drive connector board cable is attached, and then
disconnect the optical drive connector board cable
(1)
from the system board.
2.
Remove the two Phillips PM2.5×3.5 screws
(2)
that secure the optical drive connector board to
the base enclosure.
3.
Remove the optical drive connector board
(3)
from the base enclosure.
86
Chapter 4 Removal and replacement procedures
Summary of Contents for Pavilion m6
