Chapter 4
Diagnostics
33
Table 4-2. POST Error Codes
Code
Description
Problem/Solution
0000
System Board error
POST has detected a failure limited to the system board internal
functions.
To verify this error:
1. Reboot the Netserver.
Skipping this error message and continuing may result in
unstable behavior, or a system hang during the boot process.
2. If this error continues, the system board may need to be
replaced. Contact your service representative to replace your
Netserver.
0010
BIOS problem
The PC configuration has been lost, cleared, corrupted, or has
not been initialized. When the HP Netserver remains unplugged
for a long period of time, the battery will discharge and not
provide enough current to keep the CMOS memory powered.
To correct this:
1. Verify the battery is properly inserted.
2. If necessary, replace the battery as described later in this
chapter.
3. Run the
Setup Utility
to re-configure your Netserver.
0011
Battery problem
The Netserver BIOS is not responding due to a possible battery
discharge. If the HP Netserver was unplugged for a long period
of time, the battery will discharge and not provide enough
current to keep the system date and time current.
To correct this:
1. Verify the battery is properly inserted.
2. If necessary, replace the battery.
3. Set time and date using the
Setup Utility
and in your
operating system, if necessary.
0012
BIOS initialization
problem
The HP Netserver configuration has been cleared or has not
been initialized.
Run the
Setup Utility
to re-configure your Netserver.
0020
ISA initialization
problem
(This does not apply
to LP 1000r)
The ROM on the accessory board is bad or the board has a
conflict with a system board reserved resource (address, DMA,
or IRQ).
To correct this:
1. Change the resources used by the ISA accessory boards.
2. Try to disable <free> resources used by system board
devices.
3. If the problem persists, the accessory board may be
