Chapter 4
Diagnostics
34
Code
Description
Problem/Solution
defective. Contact the accessory board vendor.
0021
PCI Configuration
conflict
A configuration problem has occurred with a PCI device. The
PCI device or accessory board doesn’t match PC setup settings
or has conflicts with PC resources (reserved memory space,
IRQ or DMA channels).
To correct this:
1. Clear the PCI configuration with the Configuration switch.
Refer to " Clearing the CMOS Configuration."
2. If necessary, use the
Setup Utility
to manually configure the
PCI devices.
3. Check for any further PC resource, which can be used. Use
Setup Utility
to disable any unused function, such as I/O
ports or IDE controllers.
4. Start the Operating System and let it update the PCI
configuration.
0022
Plug & Play ISA
initialization problem
(This does not apply
to LP 1000r)
The Plug & Plug ISA accessory board has reported an
initialization problem. The ROM on the accessory board is bad
or the Plug & Play BIOS cannot solve a conflict issue with a
system board reserved resource.
To correct this:
1. Clear the Plug & Play configuration with the CMOS status
switch. Refer to the User's guide for details.
2. Try to disable (free) resources used by system board
devices.
3. Run the Plug & Play utility supported by your Operating
System.
4. If the problem persists, the accessory board may be
defective. Contact the accessory board vendor.
0030
Processor Speed
selection problem
(This does not apply
to LP 1000r.)
POST has detected the processor speed selected with system
board switches does not match the processor's speed.
0040
PC Serial Number
initialization problem
(This does not apply
to LP 1000r – The
system serial number
is entered in the
manufacturing
process and stored in
POST has detected the PC Serial Number has been lost or has
not been initialized.
Pressing
[F2]
will automatically run the HP Serial (BIOS) Utility
and allow you to enter the Serial Number.
