Chapter 4
Diagnostics
42
Code
Description
Problem/Solution
1. Reset the Integrated LAN by powering off the HP Netserver.
2. Disconnecting the power cord for 20 seconds.
3. Reconnect the power cord and power on the HP Netserver.
4. If the error appears upon restarting, update the system BIOS.
5. Insert the HP Navigator CD-ROM in the CD-ROM drive and
power-cycle your system.
This will initialize the flash utility on HP Navigator CD-ROM.
6. If the error persists, the system board may need to be
replaced. Contact your service representative to replace your
Netserver.
0901
Integrated LAN
enable error
The system could not enable the integrated LAN.
To correct this:
1. Reset the Integrated LAN by powering off the HP Netserver.
2. Disconnecting the power cord for 20 seconds.
3. Reconnect the power cord and power on the HP Netserver.
4. If the error appears upon restarting, update the system BIOS.
5. Insert the HP Navigator CD-ROM in the CD-ROM drive and
power-cycle your system.
This will initialize the flash utility on HP Navigator CD-ROM.
6. If the error persists, the system board may need to be
replaced. Contact your service representative to replace your
Netserver.
0A00
Display refresh rate
error
The parameters returned by the display do not match the DDC
standard used by the Netserver for automatic setup of
ergonomic refresh rates.
To correct this:
1. Disable the 'Plug & Play Display' feature in the
Setup Utility
to avoid a blank or unreadable screen at power-up.
2. Use the
Setup Utility
to manually set the video refresh rates
to the highest ergonomic refresh rates supported by the
display. Refer to the display monitor's User Guide for
specifications.
0B3x
Processor conflict
POST has detected the processors installed in the Netserver are
not the same type or speed.
To correct this:
1. Ensure both processors in the Netserver have the same
product code, which should include the type, heat sink, and
speed.
2. If not, replace one or both to ensure both are the same
product code. Contact your service representative.