Chapter 6
Replacing Parts
76
Removing a Hot Swap Drive
CAUTION
To prevent overheating or excessive electromagnetic radiation, use the filler panels
to fill the unused drive bays. If the filler panels are left out of empty drive bays while
the Netserver is operating, thermal damage and/or excessive EMI could occur.
Installing Hot Swap Hard Drives
Use this section to install the SCSI hard drives in the Hot Swap drive bays.
CAUTION
Protect the drive from static electricity by leaving it in its anti-static bag until you are
ready to install it. Before handling the drive, touch any unpainted metal surface to
discharge static electricity. When you remove the drive from the anti-static bag,
handle it only by the frame.
Do not touch
the electrical components. Place the drive on the anti-static bag
whenever you set it down.
1. Remove the filler panel from the desired drive bay location:
a. Place a thumb and index finger on the tab latches on the sides of the filler panel.
b. Press in on both tab latches to release the filler panel.
c. While keeping both tab latches depressed, pull the filler panel out of the drive bay.
