KZM-6120 Mainboard Manual
3 - 12
IRQ 8 Break Suspend
Enable this feature will make IRQ8 to resume the system from Suspend
mode. The settings are: Disabled (Default) or Enabled.
IRQ[3-7,9-15], NMI
Enable this feature will keep the system not in the Suspend mode when
IRQ3, 4, 5, 6, 7, 9, 10, 11, 12, 13, 14, 15, NMI.
The options are: Disabled (Default) or Enabled.
Date (of Month) Alarm
If Resume by Ring is set at Enabled , this feature allows you to set the day
of the alarm starts when the RTC Alarm Resume From Soft Off is set to be
Enabled. The options are: 0 (Default), 1..31.
Time (hh:mm:ss) Alarm
If Resume by Ring is set at Enabled , this feature allows you to set the time
of the alarm starts when the RTC Alarm Resume From Soft Off is set to be
Enabled. The options are: 7: 0: 0 (Default). hh (hour) - 0, 1, 2,.., 23; mm
(minute) - 0, 1, 2,..,59; ss (second) - 0, 1, 2,..,59.
Wake Up On LAN
When set at Enabled, an input signal comes from the other client/server on
the LAN awakes the system from a soft off state if connected over LAN.
The options are Disabled or Enabled (Default).
Primary IDE 0, Primary IDE 1, Secondary IDE 0, Secondary IDE 1,
Floppy Disk, Serial Port, Parallel Port
Enable this feature will keep the system not in the Suspend mode when the
selected device is active. The settings are Disabled or Enabled. The de-
fault setting is Disabled, except Serial Port.
Resume by Alarm
When set at Enabled, it allows you to set the time when the system to be
turned on from the system power-off status.
The settings are Disabled (Default) or Enabled.
