BIOS Setup
3 - 11
The options 1 Min..15 Min and When Suspend will not work concurrently.
When HDD is in the Power Saving Mode, any access to the HDD will wake
the HDD up. The options are: Disable (Default), 1 Min..15 Min, When
Suspend.
Throttle Duty Cycle
This option specifies the speed at which the system clock runs in power
saving modes. The settings are expressed as a ratio between the normal
clock speed and the power down clock speed.
The settings are 12.5 %, 25 %, 37.5 %, 50 %, 62.5 % (Default), 75%.
PCI/VGA Act-Monitor
Enable this feature to check if your PCI/VGA monitor can enter power-
saving modes. The options are: Disabled (Default), Enabled.
Soft-Off by PWR-BTTN
This feature is designed for the case when you use an ATX power supply.
The selection Delay 4 Sec. will allow the system shut down after 4 seconds
after the power button is pressed. The selection Instant-Off will allow the
system shut down immediately once the power button is pressed.
The settings are Delay 4 Sec. (Default) or Instant-Off.
PWRON After PWR-Fail
When the system is shut down owing to the power failure, the system will
not be back to power on by itself. This feature allows you to set the
system back to which power status of the system when the system power
is resumed. The options are Former-Sts (Default), On, or Off.
PowerOn by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state.
The options are Disabled or Enabled (Default).
Power On on PCI card
An input signal from outside contact with an installed PCI card that sup-
ports PCI Power Management Spec., then the card send a signal to awake
the system from a soft off state via South Bridge.
The settings are Disabled (Default) or Enabled.
