HP J4818A, Installation And Getting Started Manual

Page: 24 / 88

2-6
Installing the Series 2300 and 2500 Switches
Installation Procedures
In
st
a
ll
in
g
th
e S
e
ries 2300
and
2500
S
w
it
c
hes
2. Install Transceivers
(optional)
Install a transceiver into one or both of the slots as shown in the illustration
below. For installation details, see the instructions in the
Installation Guide
that comes with the transceiver.
The slot cover can be removed with either a flat-bladed or Torx T-10 screw-
driver. Keep the slot cover for future use.
Tr a n s c e i v e r
N o t e s
■
Any of the supported Gbps (gigabit) and 100 Mbps transceivers can be
installed in the slots in the Series 2300 and 2500 switches. See “Supported
Transceivers” below.
■ Make sure the transceivers are fully installed and that you screw
in the retaining screws to secure the transceivers in place.
■
If you do not install a transceiver in one or both of the slots, make sure
that the slot cover plate(s) is still attached over the slot for safe operation
and proper switch cooling.
■
The transceivers can be installed while the switch is powered on.
Once
the transceivers are installed, reset the switch by pressing the
Reset button on the front of the switch.
This resets/reboots the switch
which initializes and activates the transceiver. Until the switch is reset/
rebooted, the transceiver will not be operational. If you install the trans-
ceivers when the switch is powered off, powering on the switch after the
installation will initialize the transceivers.
■ In the Series 2500 and 2300 switches, the transceivers can operate only at
full duplex. Half duplex operation is not supported.
Supported Transceivers. When this manual was printed, the supported
transceivers include the following:
■
HP ProCurve Gigabit-SX Transceiver (J4131A)
■ HP ProCurve Gigabit-LX Transceiver (J4132A)
■
HP ProCurve 100/1000-T Transceiver (J4834A)
■ HP ProCurve 100-FX SC Transceiver (J4853A)
■ HP ProCurve Stacking Transceiver (part of the HP ProCurve Switch
Gigabit Stacking Kit—J4116A)
N o t e
The Gigabit-SX, and Gigabit-LX transceivers are Class 1 Laser Products
(Laser Klasse 1). They comply with IEC 825-2: 1993.
2353-ed2.book Page 6 Friday, February 9, 2001 6:00 PM