HP J4818A, Installation And Getting Started Manual

Page: 30 / 88

2-12
Installing the Series 2300 and 2500 Switches
Installation Procedures
In
st
a
ll
in
g
th
e S
e
ries 2300
and
2500
S
w
it
c
hes
Horizontal Surface Mounting
Place the switch on a table or other horizontal surface. The switch comes with
rubber feet in the accessory kit that can be used to help keep the switch from
sliding on the surface. Attach the rubber feet to the four corners on the bottom
of the switch within the embossed angled lines. Use a sturdy surface in an
uncluttered area. You may want to secure the networking cables and switch
power cord to the table leg or other part of the surface structure to help
prevent tripping over the cords.
C a u t i o n
Make sure the air flow is not restricted around the sides and back of the switch.
Wall Mounting
You can mount the switch on a wall as shown in the illustrations on the next
page.
C a u t i o n
The switch should be mounted only to a wall or wood surface that is at least
1/2-inch plywood or its equivalent.
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
For “Bookshelf” Wall Mounting For “Flat” Wall Mounting
M4 screws
M4 screws
2353-ed2.book Page 12 Friday, February 9, 2001 6:00 PM